Havis Shields Automobile Parts WGI C14 User Manual

INSTALLATION INSTRUCTIONS MODEL WGI-C14  
INTERIOR WINDOW GUARDS  
2000-2004 CHEVY TAHOE & GMC YUKON  
TOOLS REQUIRED:  
Safety goggles  
Power drill  
Phillips screwdriver  
1/8” drill bit  
HARDWARE REQUIRED:  
QTY  
24  
36  
DESCRIPTION  
#10 x ½” Phillips flat head sheet metal screw  
#10 x 3/4” Phillips pan head sheet metal screws  
PART #  
GSM33150  
GSM33195  
INSTALLATION PROCEDURE:  
1. Determine the proper cage for each window. Each guard has part number on lower left corner.  
2. Side Passenger Door Windows – Hold the screen up to the window frame. Make sure you have an  
even fit. Mark mounting holes and drill out with the 1/8” drill bit. Use #10 x ½” flat head sheet  
metal screws to attach screens to door window frame. Note: Do not over tighten screws. After the  
1/8” holes are drilled, it is helpful to indent the holes inward with a punch. This will enable the  
mounting screws to grab better.  
3. Side Cargo Area Windows – Carefully remove interior plastic trim that surrounds windows.  
Position window guard into window frame. (Guard will be approximately ½” from glass). Drill  
mount holes in window frame with 1/8” drill bit and attach guard with #10 x ¾” sheet metal screws.  
Install interior trim back to original location.  
Note: Trim should fit back on without modification, although plastic sometimes needs to be shaved  
to allow clips to go on properly.  
4. Rear Door Windows – These guards are mounted the same way as the side cargo windows.  
WGI-C14-INST-1-04  
 

Graco Water Pump 306981AD User Manual
Hamilton Beach Toaster 22502 User Manual
HANNspree Flat Panel Television MAK 000004 User Manual
Harbor Freight Tools Automobile Parts 93341 User Manual
Hotpoint Refrigerator FF4DKTVZUK User Manual
Hunter Fan Outdoor Ceiling Fan 224E+14 User Manual
Hyundai Car Stereo System H CMMD4044 User Manual
IBM Switch CMX58886CX User Manual
iHome Portable Speaker IDM12 User Manual
Impex Exercise Bike NS 1003U User Manual