Airlink Switch AKVM 2 User Manual

Ver. 1A  
Push Button  
The push button lets you directly switch between the  
computers. Simply press the button on the KVM unit  
to select the computer.  
Step 2 Connect the shared keyboard, monitor, and  
mouse to the main KVM unit. See Fig. 1.1  
Quick Installation Guide  
Model # AKVM-2  
Hotkey Sequence  
The hotkey sequence consists of three specific  
keystrokes pressd on the keyboard.  
Hotkey sequence = ScrLk + ScrLk + Command key  
The two consecutive ScrLk key should be pressed  
within 2 seconds and the following command key(s)  
should also be pressed within 2 seconds. Otherwise,  
the hotkey sequence will not be validated.  
Fig 1.1  
Section 1  
For detailed Hotkey sequences and their correspond-  
ing functions, please refer to the Quick Reference  
Chart on back.  
Step 3 Connect each set of the built-in KVM cables  
to a computer’s keyboard, video, and mouse ports.  
You can use individual standard keyboard, mouse  
and video cables to extend the cable distance, but  
depending on the type of cables you use, the  
maximum cable distance is limited to 5 ~ 7 meters  
(15.5 ~ 23 feet).  
Introduction  
The AKVM-2 switch is a 2-port PS/2 type KVM switch  
that comes with two sets of built-in 1.5M cables to save  
you cabling troubles. It enables users to access, control,  
boot, and reboot two computers using only one  
keyboard, video monitor, and mouse. Its one-piece de-  
sign offers more portability and convenience to users  
than conventional KVM switches.  
Section 4  
1
Step 4 Power up the connected computers one by  
one. After the computers are powered up, the  
keyboard and mouse will be recognized and you  
can begin operating the KVM switch.  
Technical Support  
Section 2  
Installation  
Before connecting any cable, please make sure all of your  
computers and their peripherals have been powered off.  
Otherwise, the KVM switch may not be set up properly.  
Section 3  
Operations  
Step 1 Make sure all the computers that are to be  
connected to the KVM switch and their peripherals  
are powered-off. If not, power them off before  
you proceed with the following steps.  
There are two methods to select a specific computer:  
Using the push button or the hotkey sequence.  
Continue on Back  
 

2nd Ave Coffeemaker 8900 Series User Manual
3M Projector S15i User Manual
Abit Computer Hardware SG 80DC User Manual
Addonics Technologies Computer Drive REDESP User Manual
Advantech Personal Computer PCM 3362 User Manual
Agri Fab Lawn Mower Accessory 45 02921 User Manual
Aiwa CD Player XP V732 User Manual
Audiovox Automobile Alarm AA 940 User Manual
Axis Communications Security Camera P1405 E User Manual
Azden Headphones 411UDR User Manual